Tikkurila uses cookies to ensure the best possible user experience. If you continue on our site, you will approve the use of cookies. Read more.
Tikkurila worldwide
(Previous date 01.10.2007)'

Presto LG - Coarse Filler

Presto LG Light Filler rough
DESCRIPTION M1 classified, waterborne, ready to use light filler. Filling ability: 30 mm with no cracking. Minimal shrinkage and good adhesion.
PRODUCT FEATURES Suitable for rough patching and total filling of small areas when high requirements are set for the layer thickness. Especially ideal for rough concrete and plaster premises. Forms a smooth surface, but if the surface will be painted, finishing with finer filler like Presto LH or LF is recommended.
RECOMMENDED USES Walls and ceilings in dry interior premises.

  The paint is suitable for interior walls The paint is suitable for ceilings The paint is water-borne Työväline: teräslasta
Colour Range Grey
Building material emission class M1
Can sizes 3 l, 10 l.
Thinner Water
Mixing ratio Water, normally not thinned.
Application method Smoothing trowel
Drying time at 23°C and 50% relative air humidity Sanding and painting of the surface can be carried out after the filler has totally dried, under normal conditions after 2-48 hours depending on the layer thickness, temperature and the relative humidity of the air.
Special feature The light filling material used in this filler makes it light and easy to apply.
Solids volume 53 %
Density 0.8 kg/l, ISO 2811
Storage Protect from frost.
Product code 001_6530
Shrinkage and cracking Minimal shrinkage and good adhesion.

Application conditions The surface to be treated must be dry, the temperature of the air over
5 ºC, and the relative humidity of the air below 80 %.
Preparation Unpainted surfaces:
Remove grease and dirt. Brush off any dust or loose material. Fill the surfaces directly with Presto Light Filler LG.

Previously painted surfaces:
Wash down previously painted surfaces with Maalipesu cleaning detergent and rinse thoroughly with water. Allow the surface dry before next treatment. Remove loose paint with a scraper and sand hard, glossy surfaces matt. Remove sanding dust. Apply Presto Light Filler LG with a smoothing trowel.
Filling Apply Presto light filler LG with a smoothing trowel. Sand the dried surface and remove sanding dust. Apply another filling coat, if necessary.
Cleaning of tools Clean tools with water

according to Regulation (EC) No. 1272/2008
The product is not classified as dangerous. A Safety Data Sheet is available on request.Safety Data Sheet - Presto Fillers

DECLARATION OF PERFORMANCE Declaration of Performance EN15824 Declaration of Performance EN13963

ENVIRONMENTAL and WASTE DISPOSAL Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.
TRANSPORT VAK/ADR not classified
mli311006 / rku161106 / ktu281106 / 001 6530

CE logo
Tikkurila Oyj
Kuninkaalantie 1
EN 13963:2005
Jointing material of gypsum plasterboards - Type 2A
Flexural strength
Release of dangerous substances
Reaction to fire

CE logo
Tikkurila Oyj
Kuninkaalantie 1
EN 15824:2009
Internal plaster based on organic binder
Flexural strength
≥ 0,3MPa
Reaction to fire
B -s1,d0