PRODUCT DATA SHEET
(Previous date 16.09.2013)'
Tunto Textured Wallpaper
|DESCRIPTION||Embossed paintable wallpaper made of polyester cellulose fiber.|
A paintable interior substrate for smooth or levelled concrete, plaster, chipboard and wood fiber board surfaces as well as cardboard faced gypsum board surfaces. For repair and new painting sites according to instructions for use.
|RECOMMENDED USES||Walls in dry interior premises.|
Paint consumption approx. 5 m2/l
* By following the alignment the pattern repeats seamlessly. Pattern alignment is not indispensable
|Preparation||Clean new surfaces from dirt and dust. Level surfaces if needed with suitable Tikkurila Presto filler and sand the dried surface. Remove sanding dust.|
Wash previously painted surfaces with Maalipesu detergent and rinse off carefully with water. Remove flaking and poorly attached paint. Level cracks, holes and roughness with suitable Presto filler. Sand the dried surface. Sand hard, glossy painted surfaces matt and remove sanding dust.
Remove wallpapers. Level cracks and holes with Presto LF Renovation Filler. Sand and prime the surface. Continue the treatment according to instructions above.
Apply one priming coat of Varma Primer or Luja Universal Primer.
|Wallpapering||Apply on dry wall surface adhesive that is suitable for non-woven wallpapers (e.g. Nowo Wall Adhesive from Kiilto Oy). Apply the adhesive evenly for the width of the wallpaper at a time.
Attach Tunto Textured Wallpaper on the adhesive surface either with a wallpaper brush or spatula tightly removing the air bubbles. Set the factory pre-cut edges against each other in a so-called butt seam. Wipe off immediately any excess adhesive from the seams with a damp sponge or clean cloth. Trim the wallpaper ends with a cutting knife.
|Finishing||The finishing coat can be applied as soon as the Tunto Textured Wallpaper has dried in the substrate, at the earliest after 12 hours depending on the conditions. Paint 1-2 times with e.g. Harmony or some other water-borne Tikkurila interior wall paint according to instructions for use.
Tunto Textured Wallpaper can also be treated with translucent products like Harmony Effect Paint or Taika Pearl Glaze. Then the embossed pattern remains a little lighter than the background. The glazes can be applied with a roller and leveled immediately with a brush in criss-criss direction. Note that the substrate must be solid-coloured as the wallpaper remains translucent.
Note! Wallpaper attached with Nowo Wall Adhesive can later be removed with Kiilto Oy’s wallpaper removing agents.
HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
|DECLARATION OF PERFORMANCE||Declaration of Performance EN15102|
|ENVIRONMENTAL and WASTE DISPOSAL||-|
|ser060916 / suota300813 / akk130913 / mkv300813|