 |
PRODUCT DATA SHEET 13.03.2008 |
|
Feelings Universal Primer |
||
| DESCRIPTION | Acrylate latex paint | |
| PRODUCT FEATURES | Plaster, concrete, brick, building block and boards, MDF, etc. | |
| RECOMMENDED USES | Feelings Universal Primer can be used for repainting interior surfaces previously coated with waterborne, alkyd or acid catalysed paints. | |
| TECHNICAL DATA | ||
 7  10 |
||
| Base paints | AP | |
| Colour Range | Available in white, most shades in the Feelings Interior Colour Range and pastel and mid – tone shades in the Tikkurila Symphony Colour Collection, BS 4800, RAL, NCS and most other ranges. | |
| Gloss grade | Full-matt | |
| Building material emission class | M1 | |
| Coverage | 7-10 m2/l per coat. The above should be used as a guide, as actual spreading rates will depend upon many factors including texture, porosity and application method. |
|
| Can sizes | 0,9 l, 2,7 l, 9 l, 18 l. | |
| Thinner | Water | |
| Application method |
Brush, roller or spray application.Thinning: if necessary thin by up to 10% with water |
|
| Drying time at 23°C and 50% relative air humidity |
Normally
touch-dry after ½ hour and recoatable after two hours. |
|
| Wash resistance | >2000 cycles (DIN 53778) | |
| Chemical resistance | Good (ISO 2812-1) | |
| Heat resistance | 85OC (ISO 3248) | |
| Solids volume | Approx. 36% | |
| Density | Approx. 1.4 kg/l | |
| Storage | Protect from frost. | |
| Product code | 726_0201 | |
| APPLICATION DETAILS | ||
| Application conditions | All surfaces must be dry, the temperature of the air at least +5OC, and the relative humidity of the air below 80%. | |
| Preparation | Surfaces must be clean, dry, and free from grease, dirt, oil, wax, all loose material and surface contamination. Use recommended Tikkurila products as cleaning agents and for mould removal. Use recommended Tikkurila fillers for filling cracks, nail holes, blemishes etc., and leveling of uneven surfaces. Ensure that existing glossy, gloss painted and filled surfaces are thoroughly flatted down. Ensure that all surfaces are thoroughly prepared. | |
| Painting | Stir the paint thoroughly. Prime unpainted wall and ceiling surfaces overall and spot prime all bare areas on previously painted walls and ceilings with Feelings Universal Primer
Prime absorbent surfaces with Feelings Universal Primer thinned by up to 10% with water, allow to dry. Apply the second coat unthinned. In areas of high humidity walls and ceilings should be primed with Feelings Moisture Stop prior to the application of Feelings Universal Primer. |
|
| Cleaning of tools | Clean with water immediately after use. | |
| EU VOC 2004/42/EC-limit value | (cat A/g) 30g/l(2010) Feelings Universal Primer contains VOC max. 30g/l. | |
| HEALTH AND SAFETY CLASSIFICATION | -Material Safety Data Sheet - Feelings Universal Primer | |
| ENVIRONMENTAL PROTECTION AND WASTE DISPOSAL | The product is not classified as dangerous. A Material Safety Data Sheet is available on request. | |
| TRANSPORT | VAK/ADR - | |
| ssa130308/ars200308/mpy251005 | ||
The above information, based on laboratory tests and practical experience, has been proved valid at the date marked on the product data sheet. The quality of the product is ensured by our operational system, based on the requirements of ISO 9001 and ISO 14001. As a manufacturer we cannot be responsible for any damages caused by using the product against our instructions or for inappropriate purposes.
