 |
PRODUCT DATA SHEET 01.01.1970 |
|
Presto LF - Renovation Filler |
|
|
| DESCRIPTION | M1 classified, water-borne, ready to use renovation filler. Filling ability: 4 mm without cracking. Minor shrinkage and good adhesion. | |
| PRODUCT FEATURES | Especially suitable for previously painted surfaces, total or partial filling of gypsum board, wood fibre board, smooth concrete, and plaster surfaces, but also chipboard and wood fibre board. Also ideal for filling gypsum board seams and fastening seam ribbon. | |
| RECOMMENDED USES | Walls and ceilings in dry interior premises. | |
| TECHNICAL DATA | ||
|
||
| Colour Range | Nearly White | |
| Building material emission class | M1 | |
| Can sizes | 200 ml, 500 ml, 3 l, 10 l. | |
| Thinner | Water | |
| Mixing ratio | Water, usually not thinned. | |
| Application method | Smoothing trowel |
|
| Drying time at 23°C and 50% relative air humidity | Sanding and painting of the surface can be carried out after the filler has totally dried, under normal conditions after 2-24 hours depending on the layer thickness, temperature and the relative humidity of the air. | |
| Particle/grain size | max. 0,15 mm |
|
| Solids volume | 61 % | |
| Density | 1.2 kg/l, ISO 2811 | |
| Storage | Protect from frost. | |
| Product code | 001_6531 | |
| Shrinkage and cracking | Minor shrinkage and good adhesion. | |
| APPLICATION DETAILS | ||
| Application conditions | The surface to be treated must be dry, the temperature of the air over
5 º C and the relative humidity of the air below 80 %. |
|
| Preparation | Unpainted surfaces:
Remove any dirt and grease. Brush off any dust or loose material. Plane the surfaces directly with Presto LF Renovation Filler. Previously painted surfaces: Wash down previously painted surfaces with Maalipesu (Cleaning Agent) cleaning detergent and rinse thoroughly with water. Remove loose paint with a scraper and sand hard, glossy surfaces matt. Remove sanding dust. Apply Presto LF Renovation Filler with a smoothing trowel. |
|
| Filling | Apply Presto LF Renovation Filler with a smoothing trowel. Sand the dried surface and remove sanding dust. Apply another filling coat, if necessary. | |
| Cleaning of tools | Clean tools with water. | |
| HEALTH AND SAFETY CLASSIFICATION | The product is not classified as dangerous. A Material Safety Data Sheet is available on request.Material Safety Data Sheet - Presto Fillers | |
| ENVIRONMENTAL PROTECTION AND WASTE DISPOSAL | Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations. | |
| TRANSPORT | VAK/ADR - | |
| ssa250208/rku280208/ars260308/001 653 | ||
The above information, based on laboratory tests and practical experience, has been proved valid at the date marked on the product data sheet. The quality of the product is ensured by our operational system, based on the requirements of ISO 9001 and ISO 14001. As a manufacturer we cannot be responsible for any damages caused by using the product against our instructions or for inappropriate purposes.
