Tikkurila worldwide
PRODUCT DATA SHEET
01.09.2012

Supi Lattiaöljy (Floor Oil)

Supi Lattiaoljy 1L 1[1]
DESCRIPTION Suitable for protection of bare wood or previously oiled surface in interior wet rooms. Also suitable for thermally modified and hardwood.
PRODUCT FEATURES Suitable for use on wooden floors and duckboards.  
RECOMMENDED USES Wooden floors and duckboards in steam, wash and dressing rooms.

TECHNICAL DATA
  The paint is suitable for interior floors The paint is water-borne Tool: brush
The coverage of the paint on rough surfaces
8
The coverage of the paint on smooth surfaces
15
Base paints EC
Colour Range Colourless. Tinted according to Interior Wood Stains and Lacquers colour card.
Building material emission class M1
Coverage 8-15 m2/l.
Can sizes 0,9 l
Thinner Water
Application method Brush or sponge.
Drying times

Surface is dry after few hours. Ready to use after approx. 2 days. Porosity and amount of wood oil used affect the drying time.

Solids volume Approx. 14 %.
Density 1.0 kg/l, ISO 2811.
Storage Protect from frost. Once opened, use the oil during the same painting season as the product properties may change in a half empty can.
Product code 619_0070

APPLICATION DETAILS
Application conditions The surface to be painted must be dry, the temperature of the air at least +5 oC, and the relative humidity of the air below 80 %.
Preparation New bare wood surfaces:
Clean wood surface from dirt and dust. Moisten it lightly and after drying sand it with sanding paper no 230 to remove any raised wood fibres. Remove sanding dust.

Surfaces treated previously with wood oil:
Wash down with Supi Sauna Clean according to instructions, rinse carefully and allow to dry. Sand, if necessary and remove sanding dust. Remove loose paint with scraper and/or steel brush. If a visible film remains on the wood surface, remove it before treatment.
Oiling Mix Supi Floor Oil thoroughly before use and during application.
Apply once with a brush or sponge tightly so that all oil is absorbed evenly into the wood. Wipe off any excess oil after approx. 30 min. Apply evenly in continuous strokes the entire length of board to avoid overlapping. Oil treatment darkens the wood.
Pre-heat the sauna before taking it into use and ventilate well.
Maintenance treatment when needed. Surfaces exposed to continuous moisture stress need retreatment at intervals.
Cleaning of tools Clean tools with water and soap. Tikkurila Pensselipesu (Tool Cleaner) is recommended when cleaning hardened product from the brush.
Maintenance instructions Handle new surface with care for approx. 1 week. If needed, the surface can be cleaned lightly with soft brush or mop after approx. 2 days from finishing.

The surface can be cleaned at the earliest after 1 month with Supi Sauna Clean (1-2 dl detergent into 5 liters of water) to allow the product to achieve its final hardness and durability.

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
The product is not classified as dangerous. A Safety Data Sheet is available on request.Safety data sheet

ENVIRONMENTAL and WASTE DISPOSAL Recycle empty, dry cans or dispose them of in accordance with local regulations. Destroy liquid waste according to the local regulations for hazardous waste. Risk of self-ignition! Cleaning cloths or sanding dust containing the product can create fire by self-ignition. Waste like this should be collected and stored in water before disposal, or dried preferably outdoors or incinerated immediately.
TRANSPORT VAK/ADR: not classified
sre040912 / pih010912 / niear060912 / joa010912