 |
PRODUCT DATA SHEET 01.01.1970 |
|
Presto LG - Coarse Filler |
|
|
| DESCRIPTION | M1 classified, waterborne, ready to use light filler. Filling ability: 30 mm with no cracking. Minimal shrinkage and good adhesion. | |
| PRODUCT FEATURES | Suitable for rough patching and total filling of small areas when high requirements are set for the layer thickness. Especially ideal for rough concrete and plaster premises. Forms a smooth surface, but if the surface will be painted, finishing with finer filler like Presto LH or LF is recommended. | |
| RECOMMENDED USES | Walls and ceilings in dry interior premises. | |
| TECHNICAL DATA | ||
|
||
| Colour Range | Grey | |
| Building material emission class | M1 | |
| Can sizes | 3 l, 10 l. | |
| Thinner | Water | |
| Mixing ratio | Water, normally not thinned. | |
| Application method | Smoothing trowel |
|
| Drying time at 23°C and 50% relative air humidity | Sanding and painting of the surface can be carried out after the filler has totally dried, under normal conditions after 2-48 hours depending on the layer thickness, temperature and the relative humidity of the air. | |
| Special feature | The light filling material used in this filler makes it light and easy to apply. | |
| Solids volume | 53 % | |
| Density | 0.8 kg/l, ISO 2811 | |
| Storage | Protect from frost. | |
| Product code | 001_6530 | |
| Shrinkage and cracking | Minimal shrinkage and good adhesion. | |
| APPLICATION DETAILS | ||
| Application conditions | The surface to be treated must be dry, the temperature of the air over
5 ºC, and the relative humidity of the air below 80 %. |
|
| Preparation | Unpainted surfaces:
Remove grease and dirt. Brush off any dust or loose material. Fill the surfaces directly with Presto Light Filler LG. Previously painted surfaces: Wash down previously painted surfaces with Maalipesu cleaning detergent and rinse thoroughly with water. Allow the surface dry before next treatment. Remove loose paint with a scraper and sand hard, glossy surfaces matt. Remove sanding dust. Apply Presto Light Filler LG with a smoothing trowel. |
|
| Filling | Apply Presto light filler LG with a smoothing trowel. Sand the dried surface and remove sanding dust. Apply another filling coat, if necessary. | |
| Cleaning of tools | Clean tools with water | |
| HEALTH AND SAFETY CLASSIFICATION | The product is not classified as dangerous. A Material Safety Data Sheet is available on request.Material Safety Data Sheet - Presto Fillers | |
| ENVIRONMENTAL PROTECTION AND WASTE DISPOSAL | Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations. | |
| TRANSPORT | VAK/ADR - | |
| mli311006/rku161106/ktu281106/001 6530 | ||
The above information, based on laboratory tests and practical experience, has been proved valid at the date marked on the product data sheet. The quality of the product is ensured by our operational system, based on the requirements of ISO 9001 and ISO 14001. As a manufacturer we cannot be responsible for any damages caused by using the product against our instructions or for inappropriate purposes.
