 |
PRODUCT DATA SHEET 29.12.2005 |
|||||||||||||
Fontecryl PP |
||||||||||||||
| DESCRIPTION | A waterborne, one component fast drying acrylic based primer containing active anticorrosive pigments. | |||||||||||||
| PRODUCT FEATURES | Recommended e.g. as an anti-corrosive primer under powder coatings on steel. Especially suitable for dipping. Drying times can be shortened by using higher temperatures. Overcoatable with a wide range of products, also with solventborne products. | |||||||||||||
| RECOMMENDED USES | Steel surfaces. | |||||||||||||
| TECHNICAL DATA | ||||||||||||||
| Colour Range | Grey and yellow. | |||||||||||||
| Gloss groups | Matt | |||||||||||||
| Coverage |
Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated. |
|||||||||||||
| Thinner | Water | |||||||||||||
| Application method | By dip or conventional spray. | |||||||||||||
| Drying times |
Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation. |
|||||||||||||
| Solids volume | 48 ± 2 % volume | |||||||||||||
| Density | 1.2 - 1.3 kg / l | |||||||||||||
| Product code | 006 5980 and 006 5981 | |||||||||||||
| APPLICATION DETAILS | ||||||||||||||
| Application conditions | All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +15 ºC during application or drying. Relative humidity should be between 20 - 70 %. The surface temperature of the steel should remain at least 3 ºC above the dew point. | |||||||||||||
| Preparation | Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)
Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1) If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion. |
|||||||||||||
| Priming | FONTECRYL PP. | |||||||||||||
| Finishing | FONTECRYL 25, FONTECRYL 50 and powder coatings. | |||||||||||||
| Painting | By dip or conventional spray. Depending on the application method the paint can be thinned 0 - 10 %. At dipping the viscosity should be 15 - 20 s DIN 4 and at conventional spray application 20 - 30 s DIN 4. Before overcoating all the solvents and water have to be evaporated from the primer.
Note! The viscosity falls quickly when thinning the paint. |
|||||||||||||
| Cleaning of tools | FONTECLEAN 1921. | |||||||||||||
| EU VOC 2004/42/EC-limit value | The Volatile Organic Compounds amount is 40 g/litre of paint.
VOC content of paint (thinned 10 % by volume) is 35 g/l. |
|||||||||||||
| HEALTH AND SAFETY CLASSIFICATION | ||||||||||||||
| Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only. | ||||||||||||||
| Product safety data sheet | FONTECRYL PP GREY [GB-ENG] | |||||||||||||
| - | ||||||||||||||
The above information, based on laboratory tests and practical experience, has been proved valid at the date marked on the product data sheet. The quality of the product is ensured by our operational system, based on the requirements of ISO 9001 and ISO 14001. As a manufacturer we cannot be responsible for any damages caused by using the product against our instructions or for inappropriate purposes.
