 |
PRODUCT DATA SHEET 03.05.2006 |
|||||||||||||||||
Fontelac QD 80 |
 |
|||||||||||||||||
| DESCRIPTION | A waterborne, one component glossy topcoat based on an alkyd dispersion. | |||||||||||||||||
| PRODUCT FEATURES | Suitable for product painting in metal industry and for painting stations. Not suitable for immersion or constant humidity. | |||||||||||||||||
| RECOMMENDED USES | Recommended especially as a glossy finish for small tanks, agricultural machinery, haulage equipment and other machinery and equipment. | |||||||||||||||||
| TECHNICAL DATA | ||||||||||||||||||
| Features | Good gloss and colour retention in climatic stress. | |||||||||||||||||
| Colour Cards | TEMASPEED FONTE tinting. | |||||||||||||||||
| Gloss groups | Gloss | |||||||||||||||||
| Coverage |
Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated. |
|||||||||||||||||
| Thinner | Water | |||||||||||||||||
| Application method | By spray, brush or dipping. | |||||||||||||||||
| Drying times |
Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation. |
|||||||||||||||||
| Solids volume | 40 ± 2 volume % (ISO 3233)
52 ± 2 weight % |
|||||||||||||||||
| Density | 1,2 ± 0,1 kg/l | |||||||||||||||||
| Product code | 207-series | |||||||||||||||||
| APPLICATION DETAILS | ||||||||||||||||||
| Application conditions | All surfaces must be dry. The temperature of the ambient air, surface and paint should not fall below +10 ºC during application or drying. Relative humidity should not exceed 70 %. The surface temperature of the steel should remain at least 3 ºC above the dew point. | |||||||||||||||||
| Preparation | Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4) | |||||||||||||||||
| Priming | FONTECRYL 10, FONTECRYL AP, FONTECRYL 25, TEMAPRIME EE, TEMAPRIME EUR and TEMAPRIME GF. | |||||||||||||||||
| Finishing | FONTELAC QD 80. | |||||||||||||||||
| Painting | By spray, brush or dipping. Depending on the application method the paint can be thinned 0 - 5 %. Airless spray nozzle tip 0.011" - 0.013" and nozzle pressure 120 - 180 bar. Spray angle shall be chosen according to the shape of the object. | |||||||||||||||||
| Cleaning of tools | Water or FONTECLEAN 1921. The equipment must be cleaned immediately after use before the paint dries. | |||||||||||||||||
| EU VOC 2004/42/EC-limit value | The Volatile Organic Compounds amount is 87g/litre of paint.
VOC content of the paint (thinned 5% by volume) is 85 g/litre. |
|||||||||||||||||
| HEALTH AND SAFETY CLASSIFICATION | ||||||||||||||||||
| Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. | ||||||||||||||||||
| - | ||||||||||||||||||
The above information, based on laboratory tests and practical experience, has been proved valid at the date marked on the product data sheet. The quality of the product is ensured by our operational system, based on the requirements of ISO 9001 and ISO 14001. As a manufacturer we cannot be responsible for any damages caused by using the product against our instructions or for inappropriate purposes.
