Introduction
Systems
Working instructions
Product data sheet
Colors
Paint calculator
Safety Data Sheets
 

Ensi

A one-component urethane oil for concrete floors and walls in industry, store and cellar spaces.

The paint is solvent-borne
The coverage of the paint on rough surfaces
3
m2/l
The coverage of the paint on smooth surfaces
15
m2/l

Easy-to-use urethane oil

Ensi penetrates into concrete and withstands well abrasion and washing. The product easy to apply by brush or roller.


Ensi is mostly used for:




PRODUCT DATA SHEET
18.06.2013

Ensi - Urethane oil

 
Ensi
DESCRIPTION Urethane oil.
PRODUCT FEATURES For oiling of concrete surfaces. Penetrates into concrete without forming a protective film.
Recommended uses Suitable for concrete floors and walls in industry, store and cellar spaces.

TECHNICAL DATA
Features Withstands well abrasion and washing. Resistant against petrol, spirits and lubrication oils and grease. Resistant against vegetable and animal grease and weak solutions of acids and alkali.
Colour Range Clear.
Gloss groups Gloss
Coverage

Coverage on concrete floors is on the average:

Porous concrete surfaces:     3 - 6 m2/l

Tight concrete surfaces:    10 - 15 m2/l

 

Practical coverage depends on the porosity of the substrate and on the application method.
Thinner 1050
Application method By brush or roller.
Drying time at 23°C and 50% relative air humidity

Dust dry after      2 hours

Touch dry after    6 hours

 

Dries also in low temperature, over +5ºC.
Solids volume 30±2% volume.
Density 0.8 kg / l
Product code 005 0433

APPLICATION DETAILS
Application conditions The relative humidity of the concrete should not exceed 97 %. The temperature of the ambient air, surface or coating should not fall below +5ºC during application or drying. Relative humidity of air should not exceed 80%.
Preparation New concrete: Remove laitance by power grinding or hydrochloric acid etching. Choose the method best suited for the premises. After cleaning remove dust carefully with a vacuum cleaner. Hydrochloric acid etching is carried out with diluted hydrochloric acid (1 part concentrated hydrochloric acid, 4 parts water). Rinse with plenty of water. Dry the floor.

Old concrete: Remove all grease, oil, chemicals and other impurities by MAALIPESU detergent. Clean out pot-holes removing all loose friable material. Open cracks with e.g. an abrasive tool. Remove loose material and dust.
Priming Prime using 10-20% thinned ENSI urethane oil. Pour ENSI onto the floor and apply evenly.
Treatment Application by brush or roller.

The second treatment can be carried out after 12-24 hours after priming if necessary. Note! Apply ENSI thinly so that after drying it has completely absorbed into the concrete.
Cleaning of tools White spirit 1050.
EU VOC 2004/42/EC-limit value VOC 2004/42/EC (cat A/h) 750 g/l (2010)
Ensi: max. VOC < 750 g/l

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj.
Safety data sheetEnsi
Thinner safety data sheetEnsi
 
-


Back