PRODUCT DATA SHEET
12.08.2016

Fontefacade Structure - Acrylate structured primer

 
Tikkurila Industry 9L
DESCRIPTION A water-borne one-component, fast-drying structured acrylate exterior primer.
PRODUCT FEATURES

Recommended for fast production lines and drying in elevated temperature as well as in room temperature.


Recommended uses Suitable for exterior mineral substrates such as fibre-cement flat sheets.

TECHNICAL DATA
Features Excellent anti-blocking properties.
Good weathering resistance.
Grain size: Max 200 µm
Base paints A
Colour Cards The light shades on the Tikkurila Facade colour card.
Avatint tinting system. Only A base paint.
Gloss groups Full-matt
Coverage

Recommended spreading amounts (unthinned)

Theoretical coverage

wet

dry

final surface

150–300 g/m²

90–160 µm

3–6 m2/l


Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Thinner Water
Application method Air-assisted airless spraying or conventional spraying.
Drying times

170 g/m²

+23ºC

+40ºC

Dry to touch or stack, after

15 min

5 min


Final mechanical properties are achieved after several days. Drying and recoating times are related to the wet film thickness, thinning, color shade, temperature, the relative humidity of the air and ventilation.
Solids volume 50 by volume %
68 by weight %
Density 1.35 kg/l
Storage Must not freeze. The best storage temperature is between +15–+25°C.
Product code 84V serie

APPLICATION DETAILS
Preparation The surface to be treated has to be clean and dry. During application and drying temperature of the air, substrate and paint must be over +10°C and relative humidity of the air below 70%. Good ventilation is also very important.
Priming Fontefacade SC 10, Fontefacade SC 50 and Fontefacade CC 30.
Diluting Paint is recommended to be used without thinning. If needed thin with water max. 5%. Thinning will slow down drying times.
Painting For air-assisted airless spraying, recommended nozzle tip is 0.017"–0.019" and pressure 80–160 bar. Atomising air pressure should be about 1–3 bar. Spray angle shall be chosen according to the shape of the object.

For conventional spraying, the product is thinned approximately 0–5% with water. Recommended nozzle tip is 1.6–1.8 mm and pressure 2–3 bar.
Cleaning of tools Water.
EU VOC 2004/42/EC-limit value According to VOC Directive 2004/42/EU the product subcategory A/c VOC limit (1.1.2010) is maximum 40 g/l. VOC content of "Fontefacade Structure" is 25±10 g/l.

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
-
Safety data sheetFONTEFACADE STRUCTURE
 
ENVIRONMENTAL and WASTE DISPOSAL Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj. For industrial use only.
-


Back