Tikkurila
PRODUCT DATA SHEET
14.01.2015
 

ProSeal - Water-borne primer

Description
ProSeal is a water-borne primer with good penetrating properties. To be used for absorbing surfaces before applying BioRid, BioRid Spray or AsbestGuard.
Product features
ProSeal is suitable for priming of interior walls and ceilings, on absorbing substrates.
Recommended uses
ProSeal can also be used for binding loose or badly bonded asbestos material and binding asbestos dust, or after encapsulation or cleaning up, to bind possible loose fibers where it is difficult to vacuum clean 100% free from fibers. Read the application instructions carefully.

TECHNICAL DATA
The paint is water-borne Tool: roller Tool: spray Tool: brush
The coverage of the paint on rough surfaces
2.0
m2/l
The coverage of the paint on smooth surfaces
10
m2/l
Colour Range
Translucent
Coverage
Depending on the surfaces, but coverage should be about 2-10 m²/l.
Can sizes
5 L, 25 L
Thinner
Water
Application method
Brush, roller, or spray.

Drying time at 23°C and 50% relative air humidity
Dry to touch after 1-2 hours, depending on film thickness. Leave to dry 2-3 hours before applying BioRid, BioRid Spray or AsbestGuard
Solids volume
Approx. 13 %
Density
Approx. 1.0 kg/l (ISO 2811)
Storage
Shelf-life: 2 years. Protect from frost. Store in a dry and cool place,
protected from sunlight. Close the can carefully for future use. Open can
does not withstand long term storage.
Product code
0065122

APPLICATION DETAILS
Application conditions
The surface to be coated must be dry, the temperature of the air and surface at least
+5 °C, and the relative humidity of the air below 80 %.
Preparation
Remove dirt and dust from the surfaces. Apply BioWash, diluted with water (mixing ratio 1:2), on mold affected surfaces with a sponge, smooth brush or spray. Fill the surfaces with suitable Presto or Prestonit filler, if needed, and sand the dried surface. Remove sanding dust.
When using ProSeal prior to encapsulation with AsbestGuard or to bind loose fibres after cleaning, study the separate treatment program carefully.
Priming
Apply ProSeal 1 time with brush, roller or spray. ProSeal should not be diluted.
Cleaning of tools
Remove excess paint from tools and clean them with water. Tikkurila Tool Cleaner is recommended for removing hardened paint from the tools.
EU VOC 2004/42/EC-limit value
(cat A/h) 30g/l (2010).
ProSeal contains VOC max. 30 g/l.

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
The product is not classified as hazardous. A Safety Data Sheet is available on request.
Safety data sheet

ENVIRONMENTAL and WASTE DISPOSAL
Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.
TRANSPORT
ADR: not classified
-