PRODUCT DATA SHEET
(Previous date 29.09.2015)'
Tunto Hieno - Fine Textured Finish
|DESCRIPTION||Water-borne acrylate coating.|
|PRODUCT FEATURES||Suitable for new or previously painted concrete, screeded surface, brick, wooden fibreboard, gypsum board or chipboard wall surfaces when a textured coating is desired. TUNTO Fine can also be applied on ceilings.|
|RECOMMENDED USES||Walls and ceilings in dry interiors|
|Base paints||AP and C|
|Colour Range||Can be tinted to the colours of the TUNTO Colour Card. Lighting conditions and surface structure of the product will contribute to the final colour effect. Product must be premixed before tinting.|
|Coverage||1-9m2/l depending on the painting method as follows:
- thick rolling 1-1,5m2/l
- thin rolling 4-5 m2/l
- brushing 2-2,5m2/l
- thick spatula 2-2,5m2/l
- thin spatula 7-9m2/l
|Can sizes||2.7 l, 9 l.|
|Application method||Apply with roller and for patterning use e.g. a wide brush, wallpaper knife, firm brush or patterning roller.
Thinning: With water
|Drying time at 23°C and 50% relative air humidity||Re-coatable after 24 hours.|
|Solids volume||Approx. 53 %.|
|Density||1.0 kg/l, ISO 2811.|
|Storage||Protect from frost.|
|Application conditions||The surface to be treated must be dry, and the temperature of the air, surface and coating must be at least +5˚C and the relative humidity of the air below 80 %.|
Clean unpainted surfaces from dirt and dust. If necessary, smooth the surfaces with a suitable Presto Light Filler. Prime with Varma Primer. Apply 1-2 coats of Harmony or Nova 7 tinted to the colour of the final product.
Previously painted surfaces:
Wash down previously painted surfaces with Maalipesu cleaning agent and rinse carefully with water. If necessary, smooth the surfaces with a suitable Presto Filler. Use sandpaper to sand painted glossy surfaces until they are matt and remove the grinding dust. If the colour difference between the substrate and the finish is significant, we recommend to apply one coat of Harmony or Nova 7 tinted to the colour of the final product.
|Painting||Stir TUNTO Fine Textured Finish well before use. Use a roller to apply the product. The surface can be patterned e.g. with a wide brush, wallpaper knife, firm brush or patterning roller. Spread the coating in a thick layer on interior walls approximately one m2 at a time and make the final patterning on the surface immediately. Avoid too thick layers because they may cause the dry surface to crack. For a homogeneous surface reserve enough coating mixed in a single container to avoid possible colour difference.|
|Filling||If plain paintwork or a different kind of structure surface is wanted, level Tunto surface with suitable Tikkurila Presto filler. Continue treatment as in: Preparation Unpainted surfaces.|
|Cleaning of tools||Clean tools with water. Tikkurila Pensselipesu Tool Cleaner is recommended to remove slightly hardened finish.|
|Maintenance instructions||Clean surfaces by dry cleaning with a vacuum cleaner, soft brush or dust towel.
Handle the surfaces with care after the finishing treatment, as the product achieves the final hardness and durability after approx. one month in normal conditions.
HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
|The product is not classified as dangerous. A Safety Data Sheet is available on request.Safety data sheet|
|ENVIRONMENTAL and WASTE DISPOSAL||Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.|
|TRANSPORT||VAK/ADR: not classified|
|ser040117 / oa100112 / ktu150607 / mkv281016|