PRODUCT DATA SHEET
(Previous date 16.11.2006)'
Paneeli-Ässä Hirsisuoja - Log Protection
|DESCRIPTION||Water-borne acrylate protective agent for interior use on untreated wood, panels and log surfaces. Also suitable for concrete and brick. The product forms a dirt- and water-repellent film. Contains anti-mould agent that protects the treated surface.|
|PRODUCT FEATURES||For interior use on untreated wood, panels and log surfaces. Also suitable for concrete and brick. The product forms a dirt- and water-repellent film.|
|RECOMMENDED USES||Panelled and log surfaces, walls, ceilings, doors, etc.|
|Colour Range||Tikkurila Interior Wood Stains and Lacquers colour card, Lapponia colour card.|
|Building material emission class||M1|
|Coverage||8 - 12 m2/l
|Can sizes||0.9 l, 2.7 l and 9 l|
|Application method||Brush or spray
|Drying time at 23°C and 50% relative air humidity||Dust dry after 1/2 hour, sandable and re-coatable after 2-3 hours. Ready to use on the following day. The lacquered surface achieves its final hardness after 2 weeks. Cleaning, hard stress and placing of objects
on the surface should be avoided before this time.
|Solids volume||approx. 16 %.|
|Density||1.0 kg/l, ISO 2811|
|Storage||Protect from frost.|
|Application conditions||The surface to be treated must be dry, the temperature of the air at least 10 ºC, and the relative humidity of the air below 80 %.|
|Preparation||Remove all dirt and dust. Rough wooden surfaces can be sanded before treatment.Wet the surface slightly with a sponge or a mop. After the surface has dried, sand the raised wood fibres. Remove sanding dust.|
Stir Panel-Ace Log Treatment thoroughly before use and occasionally during application. Thin with water, if necessary. Apply the lacquer twice in the direction of the grain. Apply a test coat on a piece of wood to make sure that the colour of the tinted product is correct. The final colour of the surface depends on timber species, hardness of timber, its original colour and the number of treatments. Always thin tinted product 20 – 30 % for the first lacquering. Desired colour and gloss grade are usually achieved after two coats. Treat the entire surface in one go to avoid overlapping, large panel surfaces a few boards at a time.
|Cleaning of tools||Clean tools with water or with Tikkurila Pensselipesu (Tool Cleaner).|
|Maintenance instructions||At the earliest after 1 month from application.
Clean the surface with neutral cleaning agent (pH 6-8) using a damp squeezed cleaning equipment , soft brush or cleaning cloth. The surface must not be left wet. Very dirty surfaces can be cleaned with a slightly alkaline (pH 8-10) detergent using e.g. a cleaning cloth or sponge. Rinse the surface thoroughly.
|Maintenance treatment||Maintenance lacquering of Panel-Ace Log Treatment can be done with the same or a similar water-borne protective agent.|
|EU VOC 2004/42/EC-limit value||(cat A/f) 130g/l(2010. Paneeli-Ässä Log Protection contains VOC max. 130 g/l.|
HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
|The product is not classified as dangerous. A Safety Data Sheet is available at request.Safety data sheet|
|ENVIRONMENTAL and WASTE DISPOSAL||Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.|
|TRANSPORT||ADR/RID not classified|
|mli011106 / lko141106 / tho021106 / 847 6404|