PRODUCT DATA SHEET
(Previous date 01.10.2007)'
Presto LH - Light Filler
|DESCRIPTION||M1 classified, waterborne, ready to use light filler. Filling ability: 4 mm with no cracking. Minimal shrinkage and good adhesion.|
|PRODUCT FEATURES||Especially suitable for filling a grey base such as gypsum board, concrete, light concrete and plaster surfaces, but also chipboard and wood fibre board finishes. Also ideal for filling gypsum board seams.|
|RECOMMENDED USES||Walls and ceilings in dry interior premises.|
|Building material emission class||M1|
|Can sizes||3 l, 10 l.|
Method: Smoothing trowel
The light filling material used in this filler makes it light and easy to apply.
|Drying time at 23°C and 50% relative air humidity||Sanding and painting of the surface can be carried out after the filler has totally dried, under normal conditions after 2-24 hours depending on the layer thickness, temperature and the relative humidity of the air.|
|Special feature||The light filling material used in this filler makes it light and easy to apply.|
|Solids volume||59 %|
|Density||1.1 kg/l, ISO 2811|
|Storage||Protect from frost.|
|Shrinkage and cracking||Minimal shrinkage and good adhesion.|
|Application conditions||The surface to be treated must be dry, the temperature of the air over 5 ºC, and the relative humidity of the air below 80 %.|
Remove any dirt. Brush off any dust or loose material. Fill the surfaces directly with Presto Light Filler LH.
Previously painted surfaces:
Wash down previously painted surfaces with Maalipesu cleaning detergent and rinse thoroughly with water. Allow the surface dry before next treatment. Remove loose paint with a scraper and sand hard, glossy surfaces matt. Remove sanding dust. Apply Presto Light Filler LH with a smoothing trowel.
|Filling||Apply Presto light filler LH with a smoothing trowel. Sand the dried surface and remove sanding dust. Apply another filling coat, if necessary.|
|Joint sealing||Apply the filler into the seam with a smoothing trowel. Press the seam ribbon immediately onto the wet filler surface with a smoothing trowel. Apply more filler on top of the seam ribbon. Sand the surface after the filler has dried and remove sanding dust. Apply another filling coat, if necessary.|
|Cleaning of tools||Clean tools with water.|
HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
|The product is not classified as dangerous. A Safety Data Sheet is available on request.Safety Data Sheet - Presto Fillers|
|DECLARATION OF PERFORMANCE||Declaration of Performance EN13963 Declaration of Performance EN15824|
|ENVIRONMENTAL and WASTE DISPOSAL||Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.|
|TRANSPORT||VAK/ADR not classified|
|joa170613 / ins300404 / pih140613 / 001 6531|