PRODUCT DATA SHEET
(Previous date 01.10.2007)'
Presto LV - Humid Room Filler
|DESCRIPTION||Waterborne, ready to use light humid room filler. Filling capacity: 4 mm with no cracking. Minimal shrinkage and good adhesion.|
|PRODUCT FEATURES||Suitable for total and partial filling of gypsum board, wood fibre board, concrete and plaster surfaces in humid interior premises. Excellent for fastening joint tape.|
|RECOMMENDED USES||Walls and ceilings in humid interior premises e.g. bathrooms before painting, fastening of plastic finish or tiling.|
|Can sizes||3 l, 10 l.|
|Mixing ratio||Water, normally not thinned.|
|Application method||Smoothing trowel|
|Drying time at 23°C and 50% relative air humidity||Sanding of the surface can be carried out after the filler has totally dried, under normal conditions after 2-24 hours depending on the layer thickness, temperature and the relative humidity of the air. Painting, tiling or fastening the wall cover can be done after the filling has totally dried.|
|Special feature||The light filling material used in this filler makes it light and easy to apply.|
|Solids volume||61 %|
|Density||1.1 kg/l, ISO 2811|
|Storage||Protect from frost.|
|Shrinkage and cracking||Minimal shrinkage and good adhesion.|
|Application conditions||The surface to be treated must be dry, the temperature of the air over 5 ºC, and the relative humidity of the air below 80 %.
Remove grease and dirt. Brush off any dust or loose material. Fill the surfaces directly with Presto LV Light Humid Room Filler.
Previously painted surfaces:
Wash down previously painted surfaces with Maalipesu cleaning detergent and rinse thoroughly with water. Allow the surface dry before next treatment. Remove loose paint with a scraper and sand hard, glossy surfaces matt. Remove sanding dust. Apply Presto LV Light Humid Room Filler with a smoothing trowel.
|Filling||Apply Presto LV Light Humid Room Filler with a smoothing trowel. Sand the dried surface and remove sanding dust. Apply another filling coat, if necessary.|
|Cleaning of tools||Clean tools with water|
HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
|The product is not classified as dangerous. A Safety Data Sheet is available on request.Safety Data Sheet - Presto Fillers|
|DECLARATION OF PERFORMANCE||Declaration of Performance EN13963 Declaration of Performance EN15824|
|ENVIRONMENTAL and WASTE DISPOSAL||Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.|
|TRANSPORT||VAK/ADR not classified|
|joa170613 / pih140613 / 001 6533|