Tikkurila
PRODUCT DATA SHEET
28.06.2013
(Previous date 01.10.2007)
 

Presto LV - Humid Room Filler

Description
Waterborne, ready to use light humid room filler. Filling capacity: 4 mm with no cracking. Minimal shrinkage and good adhesion.
Product features
Suitable for total and partial filling of gypsum board, wood fibre board, concrete and plaster surfaces in humid interior premises. Excellent for fastening joint tape.
Recommended uses
Walls and ceilings in humid interior premises e.g. bathrooms before painting, fastening of plastic finish or tiling.

TECHNICAL DATA
The paint is suitable for interior walls The paint is suitable for ceilings The paint is water-borne Tool: trowel
Colour Range
Grey
Can sizes
3 l, 10 l.
Thinner
Water
Mixing ratio
Water, normally not thinned.
Application method
Smoothing trowel
Drying time at 23°C and 50% relative air humidity
Sanding of the surface can be carried out after the filler has totally dried, under normal conditions after 2-24 hours depending on the layer thickness, temperature and the relative humidity of the air. Painting, tiling or fastening the wall cover can be done after the filling has totally dried.
Special feature
The light filling material used in this filler makes it light and easy to apply.
Solids volume
61 %
Density
1.1 kg/l, ISO 2811
Storage
Protect from frost.
Product code
001_6533
Shrinkage and cracking
Minimal shrinkage and good adhesion.

APPLICATION DETAILS
Application conditions
The surface to be treated must be dry, the temperature of the air over 5 ºC, and the relative humidity of the air below 80 %.
Preparation
Unpainted surfaces:
Remove grease and dirt. Brush off any dust or loose material. Fill the surfaces directly with Presto LV Light Humid Room Filler.

Previously painted surfaces:
Wash down previously painted surfaces with Maalipesu cleaning detergent and rinse thoroughly with water. Allow the surface dry before next treatment. Remove loose paint with a scraper and sand hard, glossy surfaces matt. Remove sanding dust. Apply Presto LV Light Humid Room Filler with a smoothing trowel.
Filling
Apply Presto LV Light Humid Room Filler with a smoothing trowel. Sand the dried surface and remove sanding dust. Apply another filling coat, if necessary.
Cleaning of tools
Clean tools with water

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
The product is not classified as dangerous. A Safety Data Sheet is available on request.
Safety Data Sheet - Presto Fillers


ENVIRONMENTAL and WASTE DISPOSAL
Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.
TRANSPORT
VAK/ADR not classified
joa170613 / pih140613 / 001 6533


CE
CE logo
Tikkurila Oyj
Kuninkaalantie 1
FI-01300 Vantaa
13
Nro TIK-1650-5004a
EN 13963:2005
Jointing material of gypsum plasterboards - Type 3A
Flexural strength
> 320 N
Release of dangerous substances
NPD
Reaction to fire
A2-s1,d0


CE
CE logo
Tikkurila Oyj
Kuninkaalantie 1
FI-01300 Vantaa
13
Nro TIK-1650-5004b
EN 15824:2009
Internal plaster based on organic binder
Release of dangerous substances
NPD
Reaction to fire
B-s1,d0
Adhesion strength by pull off test
≥ 0,3 MPa