Siro 2 Primer and Ceiling paint
Water-borne, full-matt dispersion paint for priming and painting of ceilings.
Suitable for painting of concrete, plaster, filler, plasterboard and wood fibreboard surfaces according to instructions.
Walls and ceilings in dry interior premises.
White. Can be tinted to light colours of Tikkurila Symphony 2436 colour card. Half of the colourant amount given in the formula is used in tinting. Colour accuracy is not perfect. Check the shade, when the paint is used as finishing coat.
Building material emission class
For absorbing surfaces 5-7 m²/l. For non-absorbing surfaces 9-11 m²/l.
2.7 l, 9 l, 18 l.
Roller, brush or spray.
- nozzle 0,017" - 0,021"
- thinning 0-10 vol.-%
Drying time at 23°C and 50% relative air humidity
Dust dry after half an hour.
Recoatable after 2-4 hours.
Wet scrub resistance
SFS-EN 13300 class IV, ISO 11998.
85°C, ISO 4211-3.
approx. 30 % depending on the colour.
1.4 kg/l, ISO 2811
Protect from frost. Store in dry and cool place, protected from sunlight. Tinted paint or opened can does not withstand long-term storage. Close the lid carefully for next use.
The surface to be painted must be dry, the temperature of the air at least +5 °C, and the relative humidity of the air below 80 %.
Remove dirt and dust from the surfaces. Fill the surfaces with a suitable Tikkurila Presto or Prestonit filler, if needed, and sand the dried surface. Remove sanding dust.
Previously painted surfaces:
Wash down previously painted surfaces with Maalipesu cleaning detergent and rinse carefully with water. Fill cracks and holes with a suitable Tikkurila Presto or Prestonit filler and sand the dried surface. Remove sanding dust.
Stir Siro 2 well before use and thin with water, if necessary. Apply 1-2 times with a roller, spray or brush.
Cleaning of tools
Remove the excess paint from tools before cleaning with water. Tikkurila Pensselipesu (Tool Cleaner) is recommended to be used for cleaning hardened paint.
Cleaning earliest approx. 1 month after painting, if needed.
The surfaces are dry cleaned with a vacuum cleaner, soft brush or dust towel. Cleaning with a damp cloth might leave a mark on the surface.
The product achieves its final hardness and durability after one month under normal conditions, therefore the surfaces must be handled with care during this time. If the surfaces need to be cleaned soon after finishing, dry clean them with a vacuum cleaner, soft brush or a dust towel.
Surfaces painted with Siro 2 can be recoated with same type of water-borne paint. See preparation.
EU VOC 2004/42/EC-limit value
(cat A/a) 30g/l(2010)
Siro 2 contains VOC max. 30g/l.
HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
Contains 1,2-benzisothiazol-3(2H)-one and 5-chloro-2-methyl-2H-isothiazol-3-on/ 2-methyl-2H -isothiazol-3-one (3:1). May produce an allergic reaction. Wear protective gloves.
A Safety Data Sheet is available on request.
Safety data sheet
ENVIRONMENTAL and WASTE DISPOSAL
Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations.
ADR: not classified
sre051113 / linla170613 / niear121113 / pih170613 / 10V-s