PRODUCT DATA SHEET
Fontefacade SC 10 - Acrylate single-coat paint
|DESCRIPTION||A water-borne one-component, fast-drying acrylate exterior single-coat paint.|
Recommended for fast production lines and drying in elevated temperature as well as in room temperature.
The paint can be used as a primer and a topcoat.
|Recommended uses||Suitable for exterior mineral substrates such as fibre-cement flat sheets.|
|Features||• Good anti-blocking properties.
• Good weathering resistance.
Heat of Combustion (PCS): 12.5 MJ/kg according to standard EN ISO 1716, (2.4 MJ/m2 with 110 µm dry film)
Reaction to fire: A2-s1, d0 according to standard EN 13501-1 was tested with the following painting systems: Fontefacade SC 10 (200 g/m2)
|Base paints||A and C|
|Colour Cards||The shades of the Tikkurila Facade color card, RAL and NCS color card for exterior use.
Avatint tinting system.
Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
|Application method||Airless spraying and air-assisted airless spraying.|
Final mechanical properties are achieved after several days. Drying and recoating times are related to the wet film thickness, thinning, color shade, temperature, the relative humidity of the air and ventilation.
|Solids volume||48 volume %
60 weight %
|Storage||Must not freeze. The best storage temperature is between +15–+25°C.|
|Application conditions||The surface to be treated has to be clean and dry. During application and drying temperature of the air, substrate and paint must be over +10°C and relative humidity of the air below 70%. Good ventilation is also very important.|
|Preparation||Surfaces must be free of dirt, dust and grease.|
|Priming||Fontefacade SC 10.|
|Diluting||Paint is recommended to be used without thinning. If needed thin with water max. 2%. Thinning will slow down drying times.|
|Application||For airless spraying, recommended nozzle tip is 0.015"–0.019" and pressure 80–160 bar. Spray angle shall be chosen according to the shape of the object.
For air-assisted airless spraying, recommended nozzle tip is 0.015"–0.019" and pressure 80–160 bar. Atomising air pressure should be about 1–3 bar. Spray angle shall be chosen according to the shape of the object.
|Mixing of components||Stir the paint carefully before use.|
|Cleaning of tools||Water.|
|EU VOC 2004/42/EC-limit value||According to VOC Directive 2004/42/EU the product subcategory A/c VOC limit (1.1.2010) is maximum 40 g/l. VOC content of "Fonte Facade SC 10" is 30±10 g/l.|
|HEALTH AND SAFETY LABELLING|
according to Regulation (EC) No. 1272/2008
|Safety data sheet||Fontefacade SC 10|
|ENVIRONMENTAL and WASTE DISPOSAL||Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj. For industrial use only.|