PRODUCT DATA SHEET
Pinja Pro Primer - Water-borne alkyd paint
|DESCRIPTION||An all-around water-borne primer for fine-sawn timber.|
Gives good protection for 6 - 10 months.
Economical primer for claddings.
For either water-borne or alkyd topcoat.
|Recommended uses||Suitable for priming of boards and panels for exterior cladding.|
|Features||Flexible alkyd primer.|
|Colour Range||White 0301, iron oxide red 2931 and shades on the House Paint colour card.|
|Colour Cards||Avatint tinting system.|
Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Note! Dark shades made from C-base will dry slower.
Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
|Solids volume||Weight solids:
appr. 37% (243 6001)
appr. 26% (243 6003)
appr. 37% (243 0301)
appr. 23% (243 6001)
appr. 19% (243 6003)
appr. 23% (243 0301)
|Density||1.13 - 1.20 kg/litre|
|Product code||243 series|
|Application conditions||The surface to be treated has to be clean and dry. The moisture content of wood has to be below 19%. During application and drying temperature of the air, substrate and paint must be over +5°C and relative humidity of the air below 80%. Good ventilation is required to ensure optimal result. Product can be dried with or without oven.|
|Preparation||Clean surfaces from dirt, dust and loose material. Assure that surface is free from mould and blue stain.|
|Overcoating||Finish the surfaces with Pika-Teho, Vinha, Ultra or Teho at the earliest after 24 hours from priming.
Choose the colour of the primer in accordance with the colour of the finishing paint.
|Painting||Stir the product carefully before use. Avoid making foam.
For airless spraying, the product is thinned approximately 5–10% to the viscosity
30–40s (DIN4). Recommended nozzle tip is 0.013”–0.015" and pressure 120–180 bar. Spray angle shall be chosen according to the shape of the object.
For air-assisted airless spraying, the product is thinned approximately 5–10% to the viscosity 30–40s (DIN4). Recommended nozzle tip is 0.013”–0.015” and pressure 40–140 bar. Atomising air pressure should be about 1–3 bar. Spray angle shall be chosen according to the shape of the object.
Vacuum application according to manufacturer's instructions.
Wood contains resin and other coloring extractives especially in knots. Temperature and humidity fluctuations may cause paint coat discoloration in these areas.
|Cleaning of tools||Water.|
|EU VOC 2004/42/EC-limit value||The Volatile Organic Compounds amount is 8 g/litre of paint.
Maximum VOC content in ready to use paint (thinned 10% by volume) is 8 g/l.
|HEALTH AND SAFETY LABELLING|
according to Regulation (EC) No. 1272/2008
|Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj.|
|Safety data sheet||Pinja Pro Primer|