PRODUCT DATA SHEET
10.01.2017
(Previous date 11.01.2006)

Colofill - Epoxy putty

 
Colofill
DESCRIPTION A two-component, solvent-free epoxy putty.
PRODUCT FEATURES Suitable for patching of holes, cracks and seams in wood and plywood surfaces.
Recommended uses May also be used on concrete, qypsum and other mineral surfaces as well as steel surfaces. Porous mineral surfaces have to be primed with epoxy varnish or paint before patching.

TECHNICAL DATA
Features Very low amount of Volatile Organic Compounds.
Colour Range Wood.
Coverage

9 - 11 m2/l (100 μm).

Practical coverage depends on the extent of holes, cracks and seams and on the unevenness of the substrate.

Indication: about 1 litre putty/1 mm/m2.

Mixing ratio Putty 2 parts by volume 008 4611
Hardener 1 part by volume 008 4612
Application method Rubber or steel spatula.
Pot-life (+23°C) abt. 1 h after mixing.
Drying times

 

+ 23 ºC

Recoatable, after

8 h - 4 d

Ready for sanding, after

12 - 24 h

Dry through, after

7 d


Lower temperatures prolong the drying time.
Solids volume abt. 100 % by volume.
Density 1.10 kg / litre (mixture)
Product code 008 4611

APPLICATION DETAILS
Application conditions The surface to be treated has to be clean and dry. During application and drying temperature of the air, substrate and putty must be over +15°C and relative humidity of the air below 97%. Good ventilation is required to ensure optimal result. Product can be dried with or without oven.
Preparation Remove dust, loose particles and other impurities from the surface.
Priming Prime porous surfaces with Temafloor 200. In epoxy systems also the standard primer of the system can be used.
Diluting Do not thin.
Application Apply Colofill with a rubber or steel spatula. The patching is carried out to the final level of the surface avoiding surpluses. If the surface is very uneven it is recommended to apply the putty in two layers with an interval of about 8 hours. Grind the patched areas after 12 hours (+23ºC). Use dry or wet grinding or scraping.
Mixing of components First stir base and hardener separately. The correct proportions of base and hardener must be mixed thoroughly before use. Use power mixer for mixing. Insufficient mixing or incorrect mixing ratio will result in uneven drying of the surface and weaken the properties of the coating.

The amount of mixture depends on the area to be coated and on the pot life of the mixture.
Cleaning of tools Thinner 1029 or 1031.
EU VOC 2004/42/EC-limit value VOC 2004/42/EC (cat A/j) 500 g/l (2010) Colofill: max. VOC < 500 g/l

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only.
Safety data sheetColofill
Hardener safety data sheetColofill
 
-


Back