PRODUCT DATA SHEET
Ultra Pro Plus 30 - Polyacrylate exterior topcoat
|DESCRIPTION||A water-based one-component, polyacrylate exterior topcoat.|
Suitable for fast production lines and drying in elevated temperature as well as in room temperature.
|Recommended uses||Suitable for exterior wooden panels, claddings, etc.|
|Features||Good stacking properties.
Contains alkyd for improved adhesion to bare wood. The paint can be used as a primer and a topcoat.
Protects the surface against moisture, sunlight and dirt.
Extremely low water absorption, decreases the moisture cracking of the wood.
Can be coated with Ultra Classic paint in building site, if needed.
Forms a fast-drying and elastic film with low water permeability properties. 2x Ultra Pro Plus 30 provides excellent protection against water penetration, and thus suppresses cracking of timber by preventing water uptake also through the edges.
|Colour Range||The shades on the Wooden Facades colour card for exterior use.|
|Colour Cards||AVATINT tinting system.|
Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Spraying, brushing machine or vacuum.
The paint can be dried in convectional air
drying oven with temperature +40–60°C.
Drying and recoating times are related to the wet film thickness, color shade, temperature, the relative humidity of the air and ventilation.
|Solids volume||40% (A base) and 50% by weight volume
|Product code||61V serie|
|Application conditions||The surface to be treated has to be clean and dry. The moisture content of wood has to be below 20%. During application and drying temperature of the air, substrate and paint must be over +10°C and relative humidity of the air below 70%. Good ventilation is also very important.|
|Preparation||Surfaces must be free of dirt, dust and mold.|
|Priming||Ultra Pro Plus 30 is recommended to be used both as a primer and a topcoat.|
|Treatment||Stir the paint carefully before use. Avoid flotation. Thin with water if necessary.
|Thinning||Paint is recommended to be used without thinning. If needed thin with water max. 5%.|
|Application||For airless spraying the product is thinned approximately 0–5%. Recommended nozzle tip is 0.013"–0.015" and pressure 140–180 bar. Spray angle shall be chosen according to the shape of the object.
For air-assisted airless spraying, the product is thinned approximately 0–5%. Recommended nozzle tip is 0.013"–0.015" and pressure 40–140 bar. Atomising air pressure should be about 1–3 bar. Spray angle shall be chosen according to the shape of the object.
For conventional spraying, the product is thinned approximately 0–5%. Recommended nozzle tip is 1.6–2.0 mm and pressure 2–3 bar.
Wood contains resin and other colouring extractives especially in knots. Temperature and humidity fluctuations may cause paint coat discolouration in these areas.
|Cleaning of tools||Water or Tikkurila Tool Cleaner.|
|EU VOC 2004/42/EC-limit value||According to VOC Directive 2004/42/EU the product subcategory A/d VOC limit (1.1.2010) is maximum 130 g/l. VOC content of "Ultra Pro Plus 30" is 35±10 g/l.|
|HEALTH AND SAFETY LABELLING|
according to Regulation (EC) No. 1272/2008
|Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj. For industrial and professional use only.|
|Safety data sheet||ULTRA PRO PLUS 30|
|Thinner safety data sheet|