PRODUCT DATA SHEET
Ensi - Urethane oil
|PRODUCT FEATURES||For oiling of concrete surfaces. Penetrates into concrete without forming a protective film.
|Recommended uses||Suitable for concrete floors and walls in industry, store and cellar spaces.|
|Features||Withstands well abrasion and washing. Resistant against petrol, spirits and lubrication oils and grease. Resistant against vegetable and animal grease and weak solutions of acids and alkali.|
Coverage on concrete floors is on the average:
Porous concrete surfaces: 3 - 6 m2/l
Tight concrete surfaces: 10 - 15 m2/l
Practical coverage depends on the porosity of the substrate and on the application method.
|Application method||By brush or roller.|
|Drying time at 23°C and 50% relative air humidity||
Dust dry after 2 hours
Touch dry after 6 hours
Dries also in low temperature, over +5ºC.
|Solids volume||30±2% volume.|
|Density||0.8 kg / l|
|Product code||005 0433|
|Application conditions||The relative humidity of the concrete should not exceed 97 %. The temperature of the ambient air, surface or coating should not fall below +5ºC during application or drying. Relative humidity of air should not exceed 80%.|
|Preparation||New concrete: Remove laitance by power grinding or hydrochloric acid etching. Choose the method best suited for the premises. After cleaning remove dust carefully with a vacuum cleaner. Hydrochloric acid etching is carried out with diluted hydrochloric acid (1 part concentrated hydrochloric acid, 4 parts water). Rinse with plenty of water. Dry the floor.
Old concrete: Remove all grease, oil, chemicals and other impurities by MAALIPESU detergent. Clean out pot-holes removing all loose friable material. Open cracks with e.g. an abrasive tool. Remove loose material and dust.
|Priming||Prime using 10-20% thinned ENSI urethane oil. Pour ENSI onto the floor and apply evenly.|
|Treatment||Application by brush or roller.
The second treatment can be carried out after 12-24 hours after priming if necessary. Note! Apply ENSI thinly so that after drying it has completely absorbed into the concrete.
|Cleaning of tools||White spirit 1050.|
|EU VOC 2004/42/EC-limit value||VOC 2004/42/EC (cat A/h) 750 g/l (2010)
Ensi: max. VOC < 750 g/l
|HEALTH AND SAFETY LABELLING|
according to Regulation (EC) No. 1272/2008
|Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj.|
|Safety data sheet||Ensi|
|Thinner safety data sheet||Ensi|