PRODUCT DATA SHEET
12.12.2017
(Previous date 22.11.2010)

Pinja Wood Stain - Water-borne wood stain

 
Pinja Wood Stain
DESCRIPTION A fast-drying water-borne wood stain for wooden surfaces.
PRODUCT FEATURES Wood outdoor surfaces
Recommended uses Suitable for wooden window frames, front doors, panels etc.

TECHNICAL DATA
Features Protects the surface against moisture, sunlight and dirt. Decreases cracking of wood surface.
Colour Range Clear. AKVI TONE tinting according to the Translucent Wood Finishes Colour Card.
Coverage

Recommended spreading amounts (unthinned)

Theoretical coverage

wet / one layer

theoretical dry film thickness

 

 80 g/m2

10 µm

12 - 14 m2/l


Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Thinner Water
Application method Airless spraying, air-assisted airless spraying, conventional spraying, dipping and flow coating.
Drying times

 (80 - 100 g/m2)

20 ºC

50 ºC

Dry to sand, after

10 - 60 min

5 - 20 min


Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Solids volume abt. 10 % by volume, 11 % by weight.
Density 1.0 kg/litre.
Product code 314 6909 (TCW base paint)

APPLICATION DETAILS
Application conditions The surface to be treated has to be clean and dry. The moisture content of wood has to be below 20%. During application and drying temperature of the air, substrate and paint must be over +18°C and relative humidity of the air below 70%. Good ventilation is required to ensure optimal result. Product can be dried with or without oven.
Preparation Clean surfaces from dirt, dust and loose material. Assure that surface is free from mold and blue stain.
Application Stir the product carefully before use. Avoid making foam. The product is recommended to be used without thinning but can be thinned with water if necessary. Let the product settle down for a while before use.

For airless spraying spraying: nozzle tip 0.009"–0.011" is recommended to be used with pressure of 80–160 bar. Spray angle shall be chosen according to the shape of the object.
For air-assisted airless spraying: nozzle tip 0.009"–0.011" is recommended to be used with pressure 40–120 bar. Atomising air pressure should be about 1–3 bar.
For conventional spraying: nozzle tip 1.0–1.4 mm is recommended to be used with pressure 1.5–3 bar.
For dip and flow coating product is ready to use.

Wood contains resin and other coloring extractives especially in knots. Temperature and humidity fluctuations may cause paint coat discoloration in these areas.
Finishing Pinja Wood Stain, Pinjalac HB, Pinja Flex 30, Ultra Pro, Pinja Pro, Pinja Top and Pinja Color Plus.
Cleaning of tools Water.
EU VOC 2004/42/EC-limit value The Volatile Organic Compounds amount is 30 g/litre of paint.

HEALTH AND SAFETY LABELLING
according to Regulation (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj. For industrial use only.
Safety data sheetPinja Wood Stain
 
-


Back