(Previous date 02.01.2006)

Temalac FD 80 - Alkyd topcoat

Temalac FD 80
DESCRIPTION A fast-drying, one-component glossy alkyd topcoat.
Recommended uses Recommended for steel structures, service platforms and different types of machinery and equipment.

Colour Cards RAL, NCS, SSG, BS, MONICOLOR NOVA and SYMPHONY colour cards. TEMASPEED tinting.
Gloss groups Gloss

Recommended film thicknesses

Theoretical coverage






11.1 m2/l



7.4 m2/l

Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
Thinner 1006 and 1053
Drying times

DFT 40µm




Dust dry, after

40 min

15 min

10 min

Touch dry, after

3 h

1½ h

1 h

Recoatable, after

12 d

6 d

4 d

Recoatable, "wet-on-wet", after

1–4 h

½–2 h

30 min

Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.

Solids volume 45 ± 2 % volume (ISO 3233)
60 ± 2 % weight
Density 1.0 - 1.2 kg / l depending on color
Product code 180-series

Application conditions All surfaces must be clean, dry and free from contamination. The temperature of the ambient air, surface and paint should not fall below +5ºC during application and drying. Relative humidity of the air should not exceed 80% during application and drying. The surface temperature of steel should remain at least 3°C above the dew point. Good ventilation and sufficient air movement is required in confined areas during application and drying.
Preparation Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4)
Priming Temaprime EE, Temaprime EUR, Temaprime GF, Temaprime ML and Fontecryl 10.
Finishing Temalac FD 80.
Painting Stir the product carefully before use.

For airless spraying, the product is thinned approximately 15–20% to the viscosity
30–40s (DIN4). Recommended nozzle tip is 0.011"–0.015" and pressure 120–180 bar. Spray angle shall be chosen according to the shape of the object.

For conventional spraying, the product is thinned approximately 20–30% to the viscosity 20–25s (DIN4). Recommended nozzle tip is 1.4–1.8 mm and pressure 3–4 bar.

"Wet-on-wet" spraying technique is recommended.
Cleaning of tools Thinner 1006.
EU VOC 2004/42/EC-limit value The Volatile Organic Compounds amount is 480 g/litre of paint.
Maximum VOC content in ready to use paint (thinned 30% by volume) is 570 g/l.

according to Regulation (EC) No. 1272/2008
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oyj.
Safety data sheetTemalac FD 80
Thinner safety data sheetTemalac FD 80